0 item(s) / Total: $0
Green Glue Noiseproofing Clips: Single Clip
Green Glue Noiseproofing Clips: Single Clip
Item Id: CLIP:QC
Retail Price: $4.79
Your Savings: $0.30
Your Price:
$4.49
Availability:
In Stock
Quantity
Noiseproofing Clips

If you're an architect or a home builder looking for an effective way to soundproof a room, look no further. Green Glue Noiseproofing Clips allow you to mechanically separate two sides of a wall so that when sound hits the wall, only one side vibrates. This keeps most of the sound from transmitting through to the other side.
 
Green Glue Noiseproofing Clips, previously known as QuietClips and WhisperClips, work better than older decoupling methods because of their fortified design. Other mechanical products like resilient channel often malfunction when screws hit a stud and create a short circuit, allowing noise to transfer. 

Green Glue Noiseproofing clips are simple to install. Measuring and screwing in clips, followed by snapping in hat channel should not take more than a few hours for an average room.

 
Specifications
    Green Glue Noiseproofing Clips are designed to isolate mid to high frequencies and excellent at addressing impact noise. Installing Noiseproofing Clips can significantly reduce sound from voices, TVs, and radios from traveling through walls. When used in ceiling/floor installations, it works to reduce the sound of footsteps to the level below.

    Green Glue Noiseproofing Clips eliminate the need for specialty drywall products, as well as complicated wall structures such as double stud or staggered stud assemblies.

    Product Specifications
    Width:1.25 in.
    Height:4.25 in.
    Depth:1 in.
    Weight:0.025 in.
    Max Spacing:48 in. on center
    Recommended Load:36 lbs ~3 drywall layers
    Max Safe Load:46 lbs ~4 drywall layers
    Fail Load:300 lbs ~27 drywall layers
    Installation

    Green Glue Noiseproofing Clips (Quiet Clips, Whisper Clips) are easy to install and require no outside assistance. You only need readily available hat channel, and a screw gun or power drill (a level and pen are also helpful).




    STEP 1 - INSTALL THE CLIPS
    Measure for placement of Green Glue Noiseproofing Clips using layout guidelines as noted above
    Mark locations and install clips using appropriate screws.
    Outermost clips must be spaced at every interval.

    STEP 2 - INSTALL THE HAT CHANNEL
    Snap appropriate hat channel into clips.

    Most walls will require you to overlap hat channel. Instructions for doing
    so are as follows: Overlap 6 inches of hat channel between two clips.
    Secure the hat channel with two 7/16 framing screws. 18 gauge tie-wire
    can also be used.

    STEP 3 - INSTALL THE DRYWALL
    Place shims on the floor to allow spacing between the drywall and the flooring. This ensures decoupling from the floor to make it impossible for vibrations to travel from wall to floor and vice-verse.
    Screw drywall in place through hat channel. Be sure drywall is fully installed before removing shims from underneath.

    STEP 4 - GREEN GLUE COVERAGE
    Use 2 to 3 tubes of Green Glue per 4' by 8' sheet of drywall. 3 tubes are required for higher performance solutions. Make sure to use the recommended amount of Green Glue for your desired results.



    For more details on Green Glue Noiseproofing Clips (QuietClips, WhisperClips) please reference our appropriate PDF downloads: