Resilmount A237R Installation Guide
Wall Installation Guide
NOTES
• Use 25 gauge furring channel on walls.
• Furring channel is installed across studs horizontally.
• Use a 4 ft. level to ensure furring channel is installed level. • Clips are spaced no further than 48 inches apart horizontally
• Hat channel must not be spaced more than 24 inches vertically
• Bottom clips must be less than 3 inches from the floor
• Top clips must be less than 6 inches from the ceiling
• Make sure to leave a 1/4 in. gap between wall and ceiling and wall and floor to fill with acoustical caulk.
STEP 1 - INSTALL THE CLIPS
Measure for placement of Resilmount A237R isolation clips using layout guidelines listed in the Installation Notes above.
Mark locations and place clips against the stud. Place washer on clips and install screw through the hole in the center of the clip.STEP 2 - INSTALL THE FURRING CHANNEL
Snap furring channel into clips.
Some walls will require you to overlap hat channel. It is best to overlap 6 inches of hat channel between two clips. Secure the hat channel with two 7/16” framing screws or 18 gauge tie-wire.
STEP 3 - INSTALL THE DRYWALL
Place shims on the floor to allow spacing between the drywall and the flooring. This ensures decoupling from the floor to make it impossible for vibrations to travel from the wall to the floor and vice-verse.
Screw drywall in place through hat channel. Be sure drywall is fully installed before removing shims from underneath.
STEP 4 - SEAL THE PERIMETER
Use acoustical sealant to fill the 1/4" gaps around the perimeter, and all gaps around electrical boxes, windows, and doors.
Ceiling Installation Guide
NOTES
• Use 25 gauge furring channel on ceilings.
• Furring channel is installed perpendicular to floor joists.
• Clips are spaced no further than 48 inches apart (every 3rd joist if joist are spaced 16 inches OC).
• Furring channel must not be spaced more than 24 inches apart.
• First and last row of clips are less than 6 inches from the wall.
• Make sure to leave a 1/4 in. gap around the perimeter of ceiling to fill with acoustical caulk.
STEP 1 - INSTALL THE CLIPS
Measure for placement of Resilmount A237R isolation clips using layout guidelines listed in the Installation Notes above.
Mark locations and place clips against the joists. Place washer on clips and install screw through the hole in the center of the clip.
STEP 2 - INSTALL THE FURRING CHANNEL
Snap furring channel into clips.
Some ceilings will require you to overlap hat channel. You can overlap 6 inches of hat channel between two clips. Secure the hat channel with two 7/16” framing screws or 18 gauge tie-wire.
STEP 3 - INSTALL THE DRYWALL
Have one person lift and hold the drywall in place. Have a second installer screw the drywall directly into the hat channel using a power drill.
Leave a 1/4" gap around the perimeter of the ceiling. This ensures decoupling from the wall to make it impossible for vibrations to travel from wall to floor and vice-verse.
STEP 4 - SEAL THE PERIMETER
Use acoustical sealant to fill the gaps around the perimeter of the ceiling, and around any lighting fixtures and vents.
0
